RUSTOLEUM CAMOUFLAGE SPRAY PAINT COMBAT HUNTING MASKS RUST-OLEUM CAMO PAINT
Rust-Oleum® Specialty Camouflage Spray provides a non-reflective, ultra-flat finish for maximum hiding. Applies to metal, wood, plaster or masonry. Offers long-lasting protection when applied on top of primer.
Use leaves and twigs as stencils.
- 340g Spray
DESCRIPTION AND USES
Rust-Oleum® Specialty Camouflage Sprays are designed to provide a non-reflective finish on hunting and sporting equipment. Various colors can be combined in a variety of patterns to blend with any terrain. Camouflage Sprays are suitable for use on vehicles, tree stands, decoys, blinds, boats and equipment. Not for use on galvanized metal.
Use outdoors or in a well ventilated area. Use when temperature is between 10-32°C and humidity is below 65% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
PRODUCT APPLICATION SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Mold and mildew must be cleaned with a chlorinated cleaner or bleach solution. Rinse with fresh water and allow to thoroughly dry.
STEEL: Scrape and wire brush or power tool clean to remove loose rust, scale, and deteriorated coatings. Use Primer for sound rusted or clean metal before application of a finish coat.
PREVIOUSLY COATED: Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy surfaces should be scarified by sanding to create a surface profile.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Shake often during use. Hold can upright 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying.
Apply a base coat of one color first. Then use leaves and twigs as stencils. Apply a base coat of colour. Lay the leaves and twigs randomly over the object you are painting. Spray over the items using three or more colours.
DRY & RECOAT
Dry and recoat times are based on 70oF (21°C) and 50% relative humidity. Dries to the touch in 20 minutes, to handle in 1 hour and can be recoated within 1 hour or after 24 hours. It is fully dry in 24 hours. Note: On plastic, maximum paint adhesion and durability is achieved in 5-7 days.
Wipe off tip before storing. Clean up wet paint with xylene or mineral spirits.