Description
Don’t mess around mixing FlakeZ™ into a messy and expensive intermediate clear coat! Instead blow the dry FlakeZ™ directly onto a wet clear coat using the new DRY FLAKE GUN! The DRY FLAKE GUN uses low pressure air to blow dry FlakeZ™ onto your job with greater control and accuracy. This gives you much more control over the FlakeZ™ being applied. Using the DRY FLAKE GUN you can even apply larger FlakeZ™ or even Shard FlakeZ™ with ease and without clogging an expensive spray gun that was built to spray liquids and not FlakeZ™!
The DRY FLAKE GUN reduces the dreaded flake build up. Applying FlakeZ™ using the old and traditional wet method, FlakeZ™ tended to stack on top of each other causing huge build ups and then miss other areas altogether leaving big valleys. The fix for this is lots of clear coats to bury the FlakeZ™ and fill the valleys followed by lots of sanding to get the job smooth again.
Using the DRY FLAKE GUN you will never get flake build up again as the dry flake will only stick to the wet or sticky clearcoat, any excess FlakeZ™ fall straight off! If you want more coverage or want to go over it with another flake color simply apply another coat of clear and hit it again with the DRY FLAKE GUN. The DRY FLAKE GUN process reduces the amount of FlakeZ and clearcoat you use as well as saving lots of time!
The DRY FLAKE GUN can also be used to apply Night MoveZ™ Glow-In-The-Dark powders with ease!
When you’re done simply unscrew the FLAKE JAR from the gun and pour the unused FlakeZ™ back into your original jar. Then clean the DRY FLAKE GUN by blowing it off with compressed air. It’s that simple!
